Chlorine Dioxide Products

NAMSA Biological Indicators Strips

Biological indicators provide repeatable, reliable evidence of a successful sterilization cycle. For chlorine dioxide sterilization cycles, biological indicators are chosen with 10⁶ (that's 1 million!) Geobacillus stearothermophilus spores inoculated on paper strips and wrapped in tyvek for their high resistance to the chlorine dioxide decontamination process. ClorDiSys features NAMSA biological indicators for the highest standard of repeatable and consistent results.

Biological indicators can be used for initial validation or as part of ongoing cycle verification procedures. Biological indicators can be placed out in the open or in more challenging areas to test the distribution and penetration properties of CD gas. Visit our Biological Indicators Page to view successful challenge areas and learn about the full power of sterilization with chlorine dioxide gas.

The ClorDiSys SCT combines both a Mix Box and Recirculation Blower to form a single, portable system to interface with any equipment that has minimal connection ports such as HEPA Filter Housings and Biological Safety Cabinets (BSCs). The Mix Box and included connection TEEs supply the means by which to inject and sample chlorine dioxide gas and humidity into the system and the regenerative blower provides a method of circulation through the system. All connections utilize standard 1” Banjo fittings.

Chlorine dioxide gas is approved by the NSF for Biogical Safety Cabinet decontamination and is one of the only decontaminating agents that can penetrate and easily decontaminate throughout HEPA filters. Optional scrubber systems can be used when BSC blowers are non-functioning or Supply HEPAs with no exhaust require decontamination.

Ideal for BSC, HEPA Housing and other limited external connection applications.

The ClorDiSys Decontamination Cart offers the ability to decontaminate small sized equipment and components inside a small portable chamber rather than in an entire room or a large fixed chamber. This allows for a quicker, more cost effective and versatile decontamination cycle by reducing the amount of time and consumables used.

The Decontamination Cart comes equipped with all necessary connections to easily interface with our Chlorine Dioxide Gas Generators. As both the Decontamination Cart and the Gas Generators are easily portable, this allows for a decontamination station to be set up anywhere in your facility. Contaminated components can then be treated near the point of contamination reducing the possibility of spreading the potential risk. Components can also be sterilized before use and then safely moved through the facility without compromising their sterility.

The Torch Tower is an inexpensive, easily transportable, powerful disinfection system designed for use in any healthcare, pharmaceutical, manufacturing, laboratory, or research setting. It is used to provide a rapid and highly effective method to disinfect surfaces, components, room surfaces and common touch points to reduce the transfer of dangerous organisms. It also offers a way to disinfect components without removing them from the room, which helps minimize the chance for cross-contamination.

The Torch contains eight high powered UVC lamps to provide quick disinfection times. It simply plugs into any standard wall outlet. Each Torch tower produces an efficient UVC output of 12 mJ/minute (0.18 mw/cm2) to get a calculated 99% reduction of MRSA in 10 seconds and Clostridium difficile in 1 minute at 10 feet.

The Torch system is designed to be so economical that multiple units are affordable enough to place into a room at the same time to eliminate shadow areas and maximize coverage for the most thorough disinfection process.

Visit www.cleanhospital.com for complete information on our Ultraviolet Light line of products.

• High UV Output: The Lantern outputs UVC light at 150 µW/cm2 to provide rapid disinfection.

• Low Power Consumption: The Lantern can be plugged into any standard 240 VAC outlet.

• Flexibility: The Lantern can either be positioned upright or hung upside down depending on the surfaces to be disinfected.

• Safety: One minute delay timer once Lantern is plugged in before light bulbs are activated in order to allow for personnel to exit.

Biosafety Pty Ltd is proud to represent UV Solutionz High Energy Germicidal UVC  Technology. UV-C Germicidal Technology is used for many applications including killing airborne and surface pathogens (Viruses, Bacteria and Moulds) that live, replicate and move through building via a buildings forced air HVAC systems.

Air borne pathogens are often introduced to a building via incoming occupants, 'fresh air' intakes and often on construction materials. An HVAC systems cooling coil which chills the air is the perfect environment for these microbial contaminants to live and thrive in that its a cold, damp and dark place. This allows a prime location for Viruses, Bacteria and Mould to reproduce and then produce air borne pathogens which can affect your building occupants health and productivity, This machinery receives very little, if any care in the way of maintenance/cleaning as it's generally are hidden away from view, often difficult to access and the microbial contaminates are invisible to the eye unless they proliferate to the point of being macroscopic. 

UV Solutionz High Energy Germicidal UVC Technology when installed in your HVAC system to our specifications has the power to destroy airborne and surface pathogens quickly and effectively, preventing them from growing and multiplying while also sterilizing the air.

UV Solutionz UVC Germicidal Technology also improves your Indoor Air Quality (IAQ) by reducing Volatile Organic Compounds (VOC) from such things as paints, carpets, renovations, outside introduced smells.

Air becomes crisper, cleaner and healthier while the operating and energy costs of your HVAC systems lower by increasing the performance of the system.